background image

– 1 –

GE Appliances

General Electric Company

Louisville, Kentucky 40225

GE Appliances

GE Cordless Gas Range

Models: JGBS14PCD  RGB518PCD

TB05-12

Training Bulletin

December 2012

INTRODUCTION

In compliance with Department of Energy requirements,  
GE has introduced 2 cordless battery-powered ignition 
30-in. free-standing gas ranges:

GE model JGBS14PCD
Hotpoint model RGB518PCD 

RANGE FEATURES

•  Standing gas pilots have been replaced with 

electronic spark ignitors.

•  Surface burners use spark ignition similar to previous 

models.

•  Ovens use a pilot burner and thermocouple 

con

fi

 guration. 

•  Oven thermostat controls both oven burner and oven 

pilot operation. 

•  Gas is used only when surface burners or oven are 

turned on.

•  AC voltage not required or used for range operation.
•  The ignitors are powered by a 9-volt battery.  
•  The battery is conveniently located in a 

compartment on the front of the range behind the 
broiler door.

•  GE models include a low battery indicator light 

located on the left side of the control panel. 

GE model 
JGBS14PCD

Hotpoint model 
RGB518PCD

Содержание JGBS14PCD

Страница 1: ...ced with electronic spark ignitors Surface burners use spark ignition similar to previous models Ovens use a pilot burner and thermocouple configuration Oven thermostat controls both oven burner and oven pilot operation Gas is used only when surface burners or oven are turned on AC voltage not required or used for range operation The ignitors are powered by a 9 volt battery The battery is convenie...

Страница 2: ...gas inlet pipe with a 1 4 in hex head screw 1 Push the thermostat knob in completely and hold it in for 10 seconds This 10 second period allows gas to be supplied and ignited at the pilot burner and heat applied to the thermocouple 2 Turn the thermostat knob to the desired temperature This allows gas to be supplied to the oven burner and ignited 3 Open the oven door and check for burner flame 3 Li...

Страница 3: ...age has damaged the battery tray receptacle terminals replace the receptacle Broiler Door To replace the battery tray receptacle 1 Remove the battery tray See To replace the battery follow steps 1 through 3 2 Remove the 2 Phillips head screws from the front of the battery tray receptacle 3 Pull the receptacle out and disconnect the wire harness 4 Insert a new battery in the battery tray 5 Slide th...

Страница 4: ...th two 1 4 in hex head screws It is necessary to remove two 1 4 in hex head screws and module cover to access the module 5 Remove the 2 Phillips head screws from the front of the control panel 6 Pull the control panel off the range 7 Using a small flat blade screwdriver remove the C clip and pull the spark ignition switch off the thermostat shaft 8 Remove the 5 8 in hex nut that attaches the oven ...

Отзывы: