Bartscher 12L-10, Инструкция по эксплуатации

Страница: 24 / 28

Installation and operation
22 / 26 162650
EN
Exchange and removal of frying oil / liquid fat in cubes (blocks)
1. The frying oil / liquid fat in cubes (blocks) should be replaced regularly when it
no longer fulfils legal requirements.
2. After cooling, the frying oil / fat in cubes (blocks) should be drained from the
basin via fat drain tap into a suitable container.
3. Make sure that the container is placed stably.
NOTE!
Remove used frying oil / fat with care for environment and according to
the valid regulations.
Fig. 6
4. Before draining the frying oil with the bayonet lock, fix the grease drain tube (13)
on the pipe stub (11).
5. Open the grease drain mechanism by pressing the lock (10) upwards, and
setting the lever (12) to the right with your other hand.
6. Carefully drain the frying oil to a collection container.
Overheating Protection System
If the fryer is accidentally switched on without frying oil / fat in cube (block), or if the
basin is filled with fat to the level below required minimum, the overheating
protection system automatically switches off the appliance. This function serves the
purpose of protecting the appliance against possible damages.
Perform the following steps:
– disconnect the appliance from mains power supply;
– leave the appliance to cool down completely;
– screw off plastic cover over the RESET button on the control box,
rotating it counter-clockwise;
– press the RESET key;
– screw the plastic cover anew by rotating it clockwise;
– switch the appliance on as usual.