EN
page 31
USER SECTION
5.4 Discharge pump system (optional)
To drain completely the wash-tank keep the machine ON, extract the overfl ow pipe and shut the door. Press
the button (5 - see chap.
4
) for at least a second: the discharge pump will automatically drain the wash-tank.
When the drain is completed, turn the machine OFF.
Turn the machine OFF and, after 5 seconds, ON (button 1 - see chap.
4
) to fi ll the wash-tank and run a new cycle.
Opening the door will stop the machine that will re-start when the door is shut.
During the wash-rinse cycle the water in excess is automatically drained.
5.5 Regeneration device (optional)
Resin regeneration by the water softener is very important.
Resin regeneration: resin regeneration should be carried out according to the number of cycles as indicated
in the picture below. Ex. 27°f (or 15°D) = 39 cycles.
To carry out the purifying cycle, follow these instructions:
•
Open the the water tap and plug in the main switch.
•
Turn the main switch 1 (see chap.
4
) to 1 (ON).
•
Open the door.
•
Remove the overfl ow tube and empty all the water in the tub.
•
Once the tank is empty check and fully replenish the salt, being careful not to spill it on the tank itself.
A strong concentration of salt can negatively aff ect the correct functioning and service life of the machine.
Fill the special container, placed on the inside of the tub, (see pict. 13) with coarse salt (1-2 mm. grains - the
maximum capacity of the bowl is 500 gr.).
•
Close the door, press button (4 - see chap.
4
) for 5 seconds and wait for the turn on of the indicator
light (d) - see chap.
4
. The indicator light (d) will come on when the cycle is activated. The resins contained
in the water softener will be automatically regenerated in about 20 minutes. The cycle is completed when the indicator
light (d) goes off . Wait 20 seconds before opening the door.
After the softening cycle, switch the machine off with button (1 - see chap.
4
).
Turn off the main wall switch.
Note:
once the cycle has begun it cannot be stopped.
If a water conditioner is installed externally, follow the instructions given in the relative manual to regenerate the resins.
• The fl ashing of the cycle lamp during the softening cycle, indicates a malfunction or a missed draining of the wash-tank
(see chapter
7
).
SALE
pict. 13
In the case of water hardness above 35°f it is advisable to install an external water softener
