8
9
INDOOR TESTING AND USE
1. Position the detector
a. Place the detector on a table with the search coil hanging over the edge.
b. Keep the search coil away from walls, floors and metal objects.
c. Remove watches, rings, jewelry and other metal items you wear.
d. Adjust the search coil, so the flat part faces towards the ceiling.
Note:
Never test the detector on a floor inside of a building. Most buildings have metal
wires in the floor which might interfere with the objects you’re testing or mask the
signal completely.
e. Turn the VOLUME switch clockwise to power on the metal detector.
2. Set up operating modes
1) Demonstrate DISCRIMINATION Feature:
a. Press DISC and then press + or - to set the DISC numeric value.
b. If the value of DISC is set to 00, the detector can detect all metals. In this
case, when the detector finds a target, the cursor above the
“Target Indicator” lights.
c. If you want to find one of the “Target Indicator” listed on the LCD, you can set
the relative numeric range of DISC by pressing DISC then + or -. For
example, the numeric range for 5¢ is 11-20, you can simply press DISC, then
set the DISC number to 11 by pr or -. If the detector finds a coin of 5¢,
the cursor above 5¢ will light.
d. You can also ignore the unwanted target by setting the DISC numeric value.
If the value is beyond the relative numeric range of the target, the target
name will not be displayed on the LCD. Meanwhile, the detector will not have
reaction to the target. For example, the numeric range for IRON is 0-10. If you
set the DISC numeric value to 11, IRON will not be displayed on LCD.
Meanwhile the detector will have no reaction to IRON during the detection.
You can ignore the unwanted target on LCD one by one from left to right by
setting the relative DISC numeric value.
Note:
- It is recommended to select the lower or medium value of the numeric range.
If you select a high value, you might miss the targets below the
selected value.
- If you don’t press the buttons (DISC/+/-) within about 2 seconds, the detector
will enter the standby mode.
2) Demonstrate NOTCH Feature
a. Press NOTCH and then press + or - to select the Target Indicator to be
notched. The cursor above the selected target will flash. Press NOTCH
again and the selected target ID will disappear after the cursor flashes
around 5 seconds.
