Surface Ceiling, Surface Wall, or Flag Mount
1. Remove the end cap with the test button and LED
indicator holes by loosening the (2) flat head screws
and set aside (Fig. 1).
2. Carefully slide out the homeplate assembly from the
inside of the housing and set aside.
3. For ceiling or wall mounting, punch out the desired
knockouts on the top or side of the housing, respectively.
For flag mounting, remove the end cap without the test
button and LED indicator holes. Set the (2) flat head
screws aside and discard the end cap.
4. For ceiling or wall mounting, secure the canopy to
the desired location on the enclosure using (2) sets
of 6-32 screws, washers, and nuts. For flag mounting,
secure the canopy by aligning the (4) holes with the
screw bosses within the housing, then fasten using
(4) 6-32 self-tapping screws (not provided).
5. Set the DIP switch on the PCB to the desired voltage.
Note:
Units equipped with the Self-test/Self-diagnostics
option do not require DIP switch adjustment.
6. Connect the battery to the PCB. Red goes to positive
(+) and black goes to negative (-) (Fig. 2).
7. Route the wires out through the canopy.
8. Slide the homeplate assembly back into the housing.
9. Slide the panel assembly into the housing.
10. Install the test button and LED indicator in the end cap
(Fig. 3).
11. Secure the end cap assembly using the (2) flat head
screws from before.
12. Install a 7/8” grommet into the center hole of the
mounting plate.
13. Route the wires out through the center hole of the mounting plate. Ensure that the mounting plate is oriented such that
the two flanges will be pointing away from the J-box.
14. Make electrical connections; see
Electrical Connections
section
15. Secure the mounting plate to the J-box.
16. Secure the canopy to the mounting plate with (4) 6-32 x1/4” screws.
900E Series
Installation Instructions
10070152 REV L - 10/19
2
800-533-3948 www.barronltg.com
Fig. 1
Fig. 2
Fig. 3
End
Cap
Homeplate
Assembly
Canopy
Battery
J-box
Test
Button
LED
Indicator
Panel Assembly
Grommet
Mounting
Plate
End
Cap
