Catch the Light Combo
Instruction Manual
12
For assistance call: 1+(716) 866-0054
Assembly – Step
3
(Program the Game)
How to exit the settings and apply the changes
1. All values are stored immediately after making
changes. You don’t have to reboot the machine in
order to apply changes.
2. Browse menu using the UP and DOWN buttons.
3. To exit the menu, press ESC or restart the
machine.
How to read counters
Counters can display large numbers (up to 6 digits)
and are using both
score displays
. For example,
when reading tickets counter, you may see:
002 on the left display
491 on the right display
This means that the machine gave 2,491 tickets.
The number on
the “credit display” is just an order
number of this settings menu position and it’s not
relevant to the counter value.
How to adjust the volume level
1. Turn ON the machine and wait for normal operation
mode.
2. Open machine and locate main board.
3. Use UP to navigate to position VPL in settings
menu.
4. Press ENT and use UP and DOWN buttons to
adjust volume value.
5.
After adjusting press ENT to confirm new setting.
6. Press ESC to go back to normal operation mode.
How to replace the SD card
1. Turn the machine OFF, open the cabinet, and
locate the SD card on the main board.
2. Press the card and it will pop out of the socket.
3. Pull the existing card out.
4. Insert the new card securely.
5. Close the machine and turn it off.
How to update the SD card
1. Turn the machine ON and check the current
software version on the credit display. Version
number is displayed only when the machine is
initializing.
2. Turn the machine OFF, open the cabinet, and
locate the SD card on the main board.
3. Press the card and it will pop out of the socket.
4. Pull the existing card out.
5. Connect the card to your computer using a card
reader or insert it directly into a computer with a
built-in reader.
WARNING:
Do not use MAC OSX. Macintosh
operating system creates hidden indexing files
and all connected drives. Those files can corrupt
the main board.
NOTICE:
Make sure your card reader is high
quality and the USB cable can power the reader.
Some low-quality card readers need additional
power supply to work correctly.
6. Check if the SD card is an old .hex file. If so,
select the file and move it to the trash bin.
7. Move a new .hex file onto the card. (Note: a new
.hex file can be requested via
[email protected]
8. Use your operating system hardware removal tool
to safely remove the SD card from the reader.
Remove the SD card.
9. Put the SD card back into the socket on the main
board of the game.
10. Turn on the machine and wait for the update
procedure to complete.
11. When updating the displays on the table will read
,,BOOT’’ then ,,ENDBOOT’’ and finally ,,INIT’’
12. After initializing, the machine will start normally.
