6
With an 1/8" drill bit
pre-drill marked hole
on angle bracket and
lock angle in place
with supplied
#10 x 3/4"
screw
Note – There is a separate screw pack
for the top rail and bottom rail brackets
a. Slide your angle brackets top/bottom onto your rails and place
your stair rail section between your posts on top of
your temporarily secured deck board
b. Mark all bracket holes
c. Remove stair railing section
d. Remove temporarily secured deck board
e. Pre-drill all bracket holes with a 1/8" drill bit
f. On your top railing brackets position a drill bit on center of
post (2" from either side) and between previously drilled four
screw holes. Pre-drill using 5/32" drill bit all the way through
the steel insert
g. Attach 2" screw into post all the way through the
steel insert
Remove stair railing section
from clamped posts
Locate your previous marked
lines on your stair railing
sections and add 1" to your
pre-determined lengths for
bracket depth and cut all four
marks with a hacksaw at 90
degrees
Note – you will have to cut
through an aluminum insert
in the top rail
7
9
8
Locking The Angle
Installing Brackets
Cutting Rails
Add 1"
a.
b.
b.
e.
f.
g.
