24
Part
Number of points to be
greased
Support point for forward/ reverse pedals
1
Support point for brake pedal
1
Support point for belt tension lever
1
Support point for pump neutral lever
1
Rhombic flange unit of front wheel
2 (2WD)
1 (3WD)
Support point for rear wheel brake lever
2
Support point for blade lever
1
6-2
Oiling of each part
●
Apply grease to the grease nipples located in the following places
every 50 hours.
6-3
Adjustment of the steering chain tension
Open the front cover.
Adjust the chain tension to an appropriate level (until almost all
looseness is eliminated, but not excessively tight) using the nuts
attached to either end of the steering chain. After completing the
adjustment, be sure to lock the nuts.
Front wheel arm
Adjustment screw
Steering chain
Nuts
1
2
6. Maintenance
6-1
Opening and closing the cover
●
Opening and closing the front cover
● Remove the dimple knobs on each side and then pull the front cover
forward until the wire is fully stretched.
●
Opening and closing the rear cover
● Release the cover fastener and lift the rear cover until it comes into
contact with the stopper. When closing the rear cover, lower it back
into place slowly while supporting it with your hands and then re-
engage the cover fastener.
Rear cover
Front cover
Cover fastener
Release
Lock
Dimple knob
A
A
● Do not open the cover in places exposed to strong wind.
● When closing the cover, be careful not to get your hand
caught.
