18
2-2
Adjustment of the steering wheel position
● The steering wheel position can
be adjusted.
● Lift the tilt lever to release the
steering wheel lock. When
the steering wheel is set in a
position appropriate for the
operation to be performed, pull
the lever back down to lock the
steering wheel in place.
2-3
Adjustment of the rake
● Before use, check the degree of wear that the fork blade and the warp
board have undergone and whether the bolts and nuts have been
loosened. Adjust the rake by performing the following steps and then
smooth the bunker to a beautiful finish.
●
Basic adjustment method
1. Lower the rake in a flat area and
move the machine about 20 cm
forward.
2. Place a wooden board with a
thickness of about 15 mm under
the warp board.
3. Adjust the position of the fork so
that the rake load is applied to
the wooden board and the fork
blades are lightly touching the
ground, and then lock it in place
with the nut.
2-4
Adjustment of the blade
● Loosen the bolt and set the small blade in place. Set it in direction A
to carry a thin layer from the surface of the sand and in direction B to
carry a thicker layer from the surface of the sand.
● You can remove the blade by performing the following steps.
Remove the pin.
Remove the blade.
Do not adjust the seat position while the machine is
travelling, it is dangerous to do so.
2. Adjustments before use
2-1
Adjustment of the seat position
● You can slide the seat forward
and backward by pulling the
seat lever in the direction
indicated by the arrows. Adjust
the seat position to one that is
appropriate for the operation to
be performed.
Seat lever
Backward
Forward
Tilt lever
Release
Lock
10 nut
Fork blade
Flat concrete surface
Wooden board or
suitable substitute
Warp board
15
Bolt
Small blade
Pin
A
B
Do not adjust the steering wheel position while the machine
is travelling, it is dangerous to do so.
Lock the steering wheel securely in place. It is extremely
dangerous to travel with it unlocked.
1
2
