Baroness LS62, Руководство по эксплуатации для владельца

Страница: 31 / 37

Reel housing side
Important
Always use a hand operated grease gun and
only add a maximum of 2 pumps of grease
every 50 hours.
Using a power assisted grease gun should be
avoided.
The grease capacity inside the reel housing
on the CR brush mount side is approximately
25 g (0.05 lb).
If you repeat greasing by 2 g (0.004 lb) twelve
times for 600 hours of operation, the grease
amount inside the housing will almost reach
its full capacity.
In case that the grease exceeds its capacity,
the brush frame may project outward.
Therefore, remove the brush frame and
discard the grease inside the reel housing
when it reaches the capacity.
8bq62b-283
Greasing Points_005
Rear roller shaft
There is one point each on the left and right
of the rear roller shaft.
Left end of rear roller
8bq62b-284
Greasing Points_006
3.
Right end of rear roller
8bq62b-285
Greasing Points_007
Maintenance Work
Cleaning of Mower Unit
Important
While cleaning, do not allow water on the
sealed parts of the reel shaft. (Avoid high-
pressure water cleaning.)
Otherwise, it may cause damage to the
machine.
Be sure to clean the mower unit after use.
Stop the engine, and then remove the key.
Carefully clean the front and back of the
mower unit with water or compressed air.
Remove any grass wrapped around the reel
cutter (cutting cylinder).
Back Lapping
Back lapping is work similar to sharpening a
cooking knife. If the edges of the reel cutter
(cutting cylinder) and the bed knife (bottom
blade) become blunt and make cutting difficult,
both the reel cutter (cutting cylinder) and the
bed knife (bottom blade) should be
simultaneously sharpened by reversing the reel
cutter (cutting cylinder) with an abrasive paste
applied.
However, back lapping is a temporary measure
and would not restore the sharpness
completely.
If the edges of the reel cutter (cutting cylinder)
and the bed knife (bottom blade) become blunt
and make cutting difficult, perform back lapping
in the following procedure.
1.
2.
3.
Maintenance
LS62
・
LS66
Maintenance
Page 5-5
Maintenance Work