Baroness LS62, Руководство по эксплуатации для владельца

Страница: 21 / 37

Adjustment before Work
Adjustment of Blade Engagement
Warning
Make sure that the parking brake is firmly
applied before performing the operation.
Caution
Be sure to perform this operation on your own.
Caution
When handling the reel cutter (cutting
cylinder) or bed knife (bottom blade), wear
gloves to protect your hands.
However, pay attention not to let the reel
cutter (cutting cylinder) catch your gloves, etc.
Otherwise, you may injure your hand or
fingers.
Important
If the CR brush is installed, loosen the left and
right bolts and nuts used to install the CR
brush before adjusting the blade engagement.
After adjusting the blade engagement, adjust
the CR brush, and then firmly tighten the
loosened bolts and nuts.
Stop the engine.
Shift the reel rotation/stop switching lever to
the "Stop" position.
1
A
B
zhz6po-013
Adjustment of Blade Engagement_001
1 Reel rotation/stop switching lever
A Rotation
B Stop
1.
2.
With the cutter adjustment nut, adjust the
engagement between the reel cutter (cutting
cylinder) and the bed knife (bottom blade) so
that newspaper (two to three sheets) will be
cut by the edge of both blades when the
blades in their entirety come slightly into
contact with each other.
Insert two or three strips of newspaper into
the space between the reel cutter (cutting
cylinder) and the bed knife (bottom blade) at
an angle of 90 degrees. Then, rotate the reel
cutter (cutting cylinder) counterclockwise (as
seen from the left side of the mower unit) by
hand to check the sharpness.
Check the sharpness of the entire range (at
three or four points) of the reel cutter (cutting
cylinder).
If there is a gap between the blade edges:
Loosen (rotate counter-clockwise) the
cutter adjustment nut to apply more
contact pressure between the reel cutter
(cutting cylinder) and the bed knife
(bottom blade).
If the reel cutter (cutting cylinder) is too
tight to turn:
Tighten (rotate clockwise) the cutter
adjustment nut to reduce the contact
pressure between the reel cutter (cutting
cylinder) and the bed knife (bottom blade).
If the blades still cannot cut well:
Perform back lapping of the reel cutter
(cutting cylinder) and the bed knife
(bottom blade).
1
2
3
2f8equ-011
Adjustment of Blade Engagement_002
1 Cutter adjustment nut
2 Spring
3 Pipe with cutter adjustment screw
3.
4.
･
･
･
Handling Instructions
LS62
・
LS66
Handling Instructions
Page 4-7
Adjustment before Work