16
Clutch cover
The clutch cover is on the left side of
the engine, covering the engine clutch.
It is secured by turning the fastenbolt
clockwise (by 4-5 turns).
Travelling wheel
The travelling wheel is used to move the machine from green to green. Set the stand
up right, pull the tire holding the lever, and the wheel will come off.
*tire air pressure 120kPa(1.2kg/cm
2
)
Transportation
Take care for the safety, when loading to/unloading from the trailer or truck.
(Considering the direction of the machine, wearing nonslip shoes, move slowly.)
When holding the machine with rope, pay attention not to bind the wires. Take care not
to tie down the engine.
[IMPORTANT] Adjustment of mowing height
Move the front roller up or down, and the mowing height can be adjusted to a maximum
of 27 mm. Use an optional bottom blade when 3 m/m mowingheight is desired.
5-9
clutch cover
fasten
fastenbolt
open
[IMPORTANT] Greasing
Periodically fill up respective grease nipples.
Exercise special care when greasing the sections where needle bearings are used.
(Intermediate shaft of the right and left gears and the intermediate shaft of the groomer)
Periodically fill up the grease nipples with approx. 1 g of grease (EXCELITE EP No.2)
(one or two times with a compact manual grease pump).
5-10
5-11
5-12
Drum
Bottom blade
Front groomer
Blade reed cylinder
Front roller
mowing
height
Every 10 hr
Every 50 hr
Left frame intermediate shaft (for Reel)
Right & left frame intermediate shaft (for Drum)
Differential gear parts
Vertical gear case intermediate shaft
Left gear cover
Reel bearing
Front roller
Vertical gear case
5-13
Right-side main unit
Left-side main unit
Every 10 hr
Every 50 hr
