Baroness LH62, Руководство по эксплуатации для владельца

Страница: 25 / 45

Adjustment of Cutting Height
Cutting Height Adjustment
Caution
Do not perform the operation with any other
persons.
Adjust the cutting height to fit your cutting
work.
Set the enclosed cutting height gauge.
Set the small screw for cutting height
setup to the cutting height.
Set the angle of the bed knife (bottom
blade) with the small screw for bed knife
angle setup.
"Bed Knife (Bottom Blade) Angle Table"
(Page 4-10)
1 2 3 4
ioqrij-004
Cutting Height Adjustment_001
1 Cutting height gauge
2 Small screw for cutting height setup
3 Small screw for bed knife angle setup
4 Small screw for groomer setup
Position the small screw for cutting height
setup set on the cutting height gauge as
well as the small screw for bed knife angle
setup against the bed knife (bottom blade),
and then adjust the rear roller.
Adjust the left and right ends of the bed
knife (bottom blade) until it is level, and
then determine the position of the rear
roller based on the angle of the bed knife
(bottom blade).
1.
[1]
[2]
2.
[1]
Loosen the cutting height adjustment
nuts, and then adjust the rear roller so
that it comes into contact with the cutting
height gauge.
Since the rear roller cannot be accurately
adjusted if the front roller is in contact
with the cutting height gauge, raise the
front roller so it is not in contact with the
cutting height gauge.
2 3
4
5 6 7 1
ioqrij-005
Cutting Height Adjustment_002
1 Rear roller
2 Cutting height adjustment nut
3 Reel cutter (cutting cylinder)
4 Front roller
5 Cutting height gauge
6 Small screw for cutting height setup
7 Small screw for bed knife angle setup
After making adjustments, firmly tighten the
cutting height adjustment nuts.
Loosen the cutting height adjustment nuts,
and then adjust the front roller so that it
comes into contact with the cutting height
gauge.
2
1
3
ioqrij-006
Cutting Height Adjustment_003
1 Front roller
2 Cutting height adjustment nut
3 Cutting height gauge
[2]
3.
4.
Handling Instructions
LH62
・
LH66
Handling Instructions
Page 4-9
Adjustment before Work