3
RESIDUAL RISK
RESIDUAL RISK
HAZARDOUS SITUATION
WARNING
Slipping or falling
The operator may slip due to water or dirt on the
floor.
When using the equipment, use individual anti-
slip protective devices.
Burn
The operator intentionally touches parts of the
equipment.
When using the equipment, use individual heat
protection devices.
Burn
The operator intentionally touches hot cooking
substances (oil, water, steam, etc.).
When using the equipment, use individual heat
protection devices.
Electric Shock
(Electrocution)
Contact with live electrical parts during
maintenance operations carried out with the
electric panel powered. The operator intervenes
(with an electric tool or without disconnecting
the power) lying on the wet floor.
Maintenance of the equipment must only be
carried out by qualified personnel provided with
personal protective devices against
electrocution.
Electric Shock
(Electrocution)
Electrocution caused by malfunction of the
grounding system or electrical protection
devices.
Install protection devices complying with
applicable regulatory requirements upstream of
the equipment.
Falling from above
The operator intervenes on the machine using
unsuitable systems to access the top part (e.g.
ladders or climbs on it).
Do not intervene on the machine using
unsuitable systems to access the top part (e.g.
ladders or climbing on it).
Overturning of loads Handling of the equipment or part of it without
suitable means.
Use suitable lifting systems or accessories
when handling the equipment or packaging.
Chemical
The operator comes into contact with chemicals
(e.g. detergent, scale remover, etc.)
Use appropriate safety measures. Always refer
to the safety data sheets and labeling of the
product used.
Use the personal protective equipment
recommended in the safety data sheets.
Cuts
Risk of cuts on the internal parts of the machine
frame during maintenance.
Maintenance must only be carried out by
qualified personnel provided with personal
protective equipment (cut-resistant gloves and
garments covering the forearm).
Crushing
The fingers/hands of personnel can be crushed
when handling movable parts.
Maintenance must only be carried out by
qualified personnel provided with personal
protective equipment (gloves).
Ergonomics
The operator intervenes on the appliance
without the necessary personal protective
equipment.
The operator must intervene on the equipment
provided with personal protective equipment.
There are risks on the machine that have not been completely eliminated from a design standpoint or with the
installation of adequate protection devices.
To provide the Customer with full information, given below are the residual risks that remain on the machine:
such actions are deemed improper and therefore strictly forbidden.
