Barnes 8DSE-HL Series, Инструкция по установке и эксплуатации

Страница: 4 / 24

4
PUMP DISCHARGE ....... 8” 125lb, Flange, Horizontal
PUMP SUCTION ............ 10” 125lb, Flange w/ 4” (102 mm)
Cleanout
LIQUID TEMPERATURE . 104°F (40°C) Continuous
BASE ELBOW ............... Cast Iron ASTM A-48, Class 30
MOTOR HOUSING ........ Cast Iron ASTM A-48, Class 30
VOLUTE ......................... Cast Iron ASTM A-48, Class 30
SEAL PLATE ................. Cast Iron ASTM A-48, Class 30
IMPELLER:
Design ........... 3 Vane, Enclosed with Bronze
Wear Ring and Pump out vanes on
Back side. Dynamically balanced,
ISO G6.3
Material ........ Cast Iron ASTM A-48, Class 30
SHAFT ............................ 416 Stainless Steel
SQUARE RINGS ............ Buna-N
DIAPHRAGM ................. Buna-N
HARDWARE .................. 300 Series Stainless Steel
PAINT ............................. Air dry enamel, top coat
SEAL Design .......... Double Mechanical in oil fi lled
pressure equalized reservoir
Material ........ Rotating Faces - Carbon
Stationary Faces - Ceramic
Elastomer - Buna-N
Hardware - 300 series stainless steel
CORD ENTRY ................ 25 Ft. (8m) Cord, Epoxy sealed
housing with secondary pressure
grommet for sealing and strain relief
SPEED ........................... 1150 RPM, 60Hz (nominal)
UPPER BEARING:
Design .......... Single Row, Ball, Oil Lubricated
Load ............. Radial
LOWER BEARING:
Design .......... Double Row, Ball, Oil Lubricated
Load ............. Radial & Thrust
MOTOR: Design .......... NEMA B, Three Phase Torque
Curve, Oil Filled, Squirrel Cage
Induction
Insulation ...... Class F
THREE PHASE .............. 240/480 Dual voltage motor.
Requires overload protection
to be included in control panel
MOISTURE SENSOR .... N/O, Requires relay in control panel
TEMP. SENSOR ............. N/C, Requires relay in control panel
OPTIONAL EQUIPMENT .. Seal Material, Impeller Trims,
Additional Cord,
SECTION: A - PUMP SPECIFICATIONS:
Manual Index