background image

20

A Crane Co. Company

420 Third Street 

83 West Drive, Bramton

Piqua, Ohio 45356 

Ontario, Canada L6T 2J6

Phone: (937) 778-8947 

Phone: (905) 457-6223

Fax: (937) 773-7157 

Fax: (905) 457-2650

www.cranepumps.com

BARNES

BARNES

®

Limited Warranty

We warrant to our immediate customer and to the ultimate consumer that products of our manufacture will be free of 
defects in material and workmanship under normal use and service for the following time periods, when installed and 
maintained in accordance with our instructions.
Pump Products: One (1) year from date of installation or (24) twenty-four months from date of shipment, whichever occurs 
fi rst. Cleaning Products: Twelve (12) months from date of installation or eighteen (18) months from date of shipment, 
whichever occurs fi rst. As used herein, “the ultimate consumer” is defi ned as the purchaser who fi rst uses the product 
after its initial installation or, in the case of product designed for non permanent installation, the fi rst owner who used 
the product. It is the purchaser’s or any sub-vendee’s obligation to make known to the ultimate consumer the terms and 
conditions of this warranty. This warranty gives you specifi c legal rights, and there may also be other rights which vary 
from state to state. In the event the product is covered by the Federal Consumer Product Warranties Law (1) the duration 
of any implied warranties associated with the product by virtue of said law is limited to the same duration as stated herein, 
(2) this warranty is a LIMITED WARRANTY, and (3) no claims of any nature whatsoever shall be made against us, until the 
ultimate consumer, his successor, or assigns, notifi es us in writing of the defect, and delivers the product and/or defective 
part(s) freight prepaid to our factory or nearest authorized service station. Some states do not allow limitations on how long 
an implied warranty lasts, so the above limitation may not apply. 

THE SOLE AND EXCLUSIVE REMEDY FOR BREACH 

OF ANY AND ALL WARRANTIES WITH RESPECT TO ANY PRODUCT SHALL BE TO REPLACE OR REPAIR AT OUR 
ELECTION, F.O.B. POINT OF MANUFACTURE OR AUTHORIZED REPAIR STATION, SUCH PRODUCTS AND/OR 
PARTS AS PROVEN DEFECTIVE. THERE SHALL BE NO FURTHER LIABILITY, WHETHER BASED ON WARRANTY, 
NEGLIGENCE OR OTHERWISE.

 Unless expressly stated otherwise, guarantees in the nature of performance 

specifi cations furnished in addition to the foregoing material and workmanship warranties on a product manufactured 
by us, if any, are subject to laboratory tests corrected for fi eld performance. Any additional guarantees, in the nature of 
performance specifi cations must be in writing and such writing must be signed by our authorized representative. Due to 
inaccuracies in fi eld testing if a confl ict arises between the results of fi eld testing conducted by or for user, and laboratory 
tests corrected for fi eld performance, the latter shall control. Components or accessories supplied by us but manufactured 
by others are warranted only to the extent of and by the terms and conditions of the original manufacturer’s warranty. 

RECOMMENDATIONS FOR SPECIAL APPLICATIONS OR THOSE RESULTING FROM SYSTEMS ANALYSES AND 
EVALUATIONS WE CONDUCT WILL BE BASED ON OUR BEST AVAILABLE EXPERIENCE AND PUBLISHED 
INDUSTRY INFORMATION. SUCH RECOMMENDATIONS DO NOT CONSTITUTE A WARRANTY OF SATISFACTORY 
PERFORMANCE AND NO SUCH WARRANTY IS GIVEN.

This warranty shall not apply when damage is caused by (a) improper installation, (b) improper voltage (c) lightning (d) 
sand or other abrasive material (e) scale or corrosion build-up due to excessive chemical content. Any modifi cation of the 
original equipment will also void the warranty. We will not be responsible for loss, damage or labor cost due to interruption 
of service caused by defective parts. Neither will we accept charges incurred by others without our prior written approval.
This warranty is void if our inspection reveals the product was used in a manner inconsistent with normal industry practice 
and\or our specifi c recommendations. The purchaser is responsible for communication of all necessary information 
regarding the application and use of the product. 

UNDER NO CIRCUMSTANCES WILL WE BE RESPONSIBLE FOR 

ANY OTHER DIRECT OR CONSEQUENTIAL DAMAGES, INCLUDING BUT NOT LIMITED TO LOST PROFITS, LOST 
INCOME, LABOR CHARGES, DELAYS IN PRODUCTION, IDLE PRODUCTION, WHICH DAMAGES ARE CAUSED 
BY ANY DEFECTS IN MATERIAL AND\OR WORKMANSHIP AND\OR DAMAGE OR DELAYS IN SHIPMENT. THIS 
WARRANTY IS EXPRESSLY IN LIEU OF ANY OTHER EXPRESS OR IMPLIED WARRANTY, INCLUDING ANY 
WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.

No rights extended under this warranty shall be assigned to any other person, whether by operation of law or otherwise, 
without our prior written approval.

Manual Index

Содержание 8DSE-HL Series

























Отзывы: