2
01-2019
IMPORTANT: READ PRIOR TO INSTALLATION
It is the responsibility of the consumer to read and follow the proceeding information.
1. The consumer is responsible for reviewing the local regulations pertaining to the installation and use of this product. Please confirm that
use of this product is in compliance with the by-laws, regulations, building codes and laws of your jurisdiction before using.
2. Check with your insurance provider concerning the installation, use, value implications and/or any other considerations in regards to
your Skyline Bench.
Steinbach Office
152 Brandt Street
Steinbach, MB R5G 0R2
T (800)-461-2278
F (204)-326-5915
Winnipeg Office
901 Gateway Road
Winnipeg, MB R2K 3L1
T (800)-342-2879
F (204)-663-4854
Vancouver Office
2104-290 Newport Drive
Port Moody, BC V3H 5N2
T (778)-689-7670
F (604)-949-0321
Calgary Office
813 McCool St. Box 1136
Crossfield, AB T0M 0S0
T (403)-946-4630
F (403)-946-4631
Note:
This manual was updated
in January 2019. Check
www.
barkmanconcrete.com/resources
for
any manual updates.
Steps
A. Place metal base plate on a secure concrete
surface and pre-drill 4 holes using a masonry drill
bit.
B. Bolt the plate to the solid concrete surface using 4
heavy duty concrete screws.
C. Once the plate is firmly fastened to the ground,
place the concrete base over top the plate so that
the hex nut
sits inside the plastic tubing.
D. Using the hex-washer head, bolt the concrete base
firmly to the plate. Make sure this is tight and that
you cannot move the base.
E. Place the cedar slab onto the bench and line up
the 2 surface holes with the anchors in the top of
the base.
F. Bolt the wood to the base using the 2 flat head
screws provided.
G. Using the lag bolt
provided, fasten the concrete
base to the wood from underneath the concrete
supporting arm.
H. Apply force by sitting and pushing on both sides of
the bench to ensure the base is properly secured.
Instructions
A
B
C
D
E
F
G
Hardware Needed
Step A.
• Masonry Drill Bit for Hammer Drill - 1/4” Hex
Shank, 5/16” Size, 6” Overall Length
Step B.
• 4 x Heavy Duty Screws - Hex-Washer Head - 3/8”
Diameter, 3” Length
