14
During working operations the operator must have sufficient visibility on areas
deemed dangerous so it makes sense to keep clean and in very good condition
mirrors that is equipped with the tractor..
Machine must not be left unattended with the engine of the tractor in motion or
ignition key inserted.
keep the machine clean from foreign matter (debris, tools, miscellaneous items) that
could damage the functioning or cause damage to the operator.
When the machine is stopped on sloping ground, use the parking brake and locking
wedges supplied with the machine.
do not operate on muddy soil, sandy or saggy..
check the state of art of the hydraulic hoses. In case of deterioration (or at least
every year) is recommended to replace them.
Do not use controls unit or hydraulic hoses as handholds. These components are
mobile and do not offer stable support.
Any modification of the machine art may cause security issues. In this case the user
will be solely responsible for any accidents.
It is strictly prohibited to remove or tamper with the safety devices..
Be sure of the good condition of the pictograms. If the pictograms are damaged must
be replaced with other to require to the original manufacturer and replaced in the
position indicated by the use and maintenance manual (section 1.9.1)
Normally, the machines are not designed for road use. Road traffic is allowed if the
machine is equipped with special accessories (e.g. self-reflective signs, flashing
lights, rear lights, etc ...) and when connected to tractors which comply with country
regulations.
In case of circulation on public roads, be sure you the tank is free of any chemical
inside it.
Before travelling on public roads, put the machine in transport position, in
accordance with the manufacturer's indications.
It is strictly prohibited the transport of persons on the machine.
The coupling of the machine to the tractor, shall be exclusively performed on
attachment points provided for this purpose in accordance with the safety
regulations in force.
Before connecting the machine make sure the weight of the front axle of the tractor is
sufficient. The laying of the ballast masses must be made on the supports provided for
this purpose in accordance with the rules of the manufacturer of the tractor. The load
on the front axle of the tractor, must not be less than 20% of the sum of the kerb
weight of the tractor and the operator.
pay attention to the risk of unintentional contact of parts of the machine with the
high voltage airlines.
Perform the turns prudently, taking into account the overhang, the length, the height
and weight of the machine.
Do not use a PTO shaft without adequate protections in accordance with legal
requirements.
Do not transit, stay or work between the tractor and the machine.
