Barco System manual E1, Инструкция по установке и эксплуатации

Страница: 104 / 124

Troubleshooting
System manual E1 105
rectangle that represents it, deselect “Attached” and click
the “Apply” button.
Tip: Since Windows 2000 and Windows XP will not let you
detach the primary display connected to a particular
controller, you may need to temporarily make another
display the primary display
Caution: if you have a single display configuration and you
have enabled DualView, Windows will not allow you to
attach the second head. This is normal and not a bug.
4. For the display which is still attached click on the
“Advanced” Button.
5. Select the “Adapter” tab and then click on the “List All
Modes” button. Select the resolution and refresh rate that
your E1 display supports from the dialog box and click “OK” .
Tip: In the Adapter box, the Adapter string shows if this
display is the First View or the Second View attached to the
display controller. Please make a note of this, so that you can
arrange the displays in the correct order later if necessary.
6. Click “OK” on the bottom of the Adapter Control Panel. If the
“OK” button on the bottom of the Adapter Control Panel is
not visible, press the
“TAB” key once and then press
“CTRL”+“Enter” to select “OK”.
7. Click “OK” in the “Windows will now apply your new
desktop settings” dialog box. Your E1 display should now
synchronize and display the Windows desktop.
8. Click “Yes” when asked, “Your desktop has been
reconfigured. Do you want to keep these settings?”
To set the resolution of the second display attached to the
BarcoMed display controller you are working with, go back to the
“Settings” tab of the “Display Properties Control Panel”. Attach
the display you detached in step 2 above, by right clicking on the
rectangle that represents it and selecting
“Attached” .
Now repeat steps
5-8
above for this display.