Barco SLite, Руководство по обслуживанию

Страница: 36 / 53

7. SLite servicing procedures
6. Gently lower down the back cover and let the weight of the back cover be carried by the two belts between the tile and the back
cover.
Caution: In case the sealing ring between the tile and the back cover is damaged, replace it with a new one before closing the
tile.
Tip: When the back cover stands in the way for servicing the tile, remove the back cover completely from the tile by releasing
the two bolts inside the tile which fasten the belts.
B
B
A
Image 7-7
A Sealing ring between tile and back cover.
B Belt.
7.4 Install the back cover of an SLite tile
C
AUTION
:
Ensure to perform this procedure in a dry and clean environment with a low humidity level. A high
humidity level inside a sealed tile will damage the internal fans and other electronic parts. Place, if necessary,
some small bags with a liquid absorbing substance (silica gel) inside the tile to absorb the remaining humidity.
Necessary tools
• Nut driver 13 mm
• Open ended spanner 10 mm
How to install the back cover of an SLite tile ?
1. Check if all internal wires are well connected.
2. Is the back cover not connected with two belts to the tile?
If yes, reconnect the two belts between the back cover and the tile, using two M6 bolts.
3. Is the sealing ring between the tile and the back cover damaged?
If yes, replace it with a new sealing ring.
4. Connect the power and data cable between the tile and the re-sync unit.
Tip: Lift up the back cover and let it rest on your chest and one arm.
5. Plug in the wire unit between the external fan and the power distribution unit. The most left fan connector on the power distribution
unit must be used for the external fan.
Note: The external fan is only activated in case the internal temperature exceed a specific temperature. The internal fans turn
immediately at start up.
32 R5976621 SLITE DISPLAY 02/09/2005