8-10
Random Access Adjustment Mode
5975958A RETRO GRAPHICS 2100LC 210198
Horizontal size
adjustment
Vertical size
adjustment
Fixed sides
Size
Highlight Size by pushing the control disc forwards or backwards
and press
ENTER
to select.
Select with
ê
or
é
then <ENTER>
<EXIT> to return.
GEOMETRY
SHIFT
SIZE
SIDE KEYSTONE
BLANKING
OPTIONS
The size can be adjusted in a vertical or horizontal direction.
Pressing the control disc to the right or to the left for a vertical re-
sizing, push the control disc forwards or backwards for a horizon-
tal re-sizing.
The default value for both directions on the bar scale is 0.
When a negative value for the horizontal size, the image will be
reduced in width, when a positive value, the image will be increased
in width. The left side of the image is fixed and only the right side
can be adjusted.
When a negative value for the vertical size, the image will be
reduced in height, when a positive value, the image will be increased
in height. The top side of the image is fixed and only the bottom side
can be adjusted.
Side keystone
Highlight Side Keystone by pressing the control disc up or down and
press
ENTER
to select.
The side keystone adjustment is used to align the image if the projector
is mounted as a non standard projection angle.
Press the control disc to the right or to the left to adjust the keystone
of the image.
When the upper part of the image is wider than the lower part of the
image, press the control disc to the left. The number indication below
the bar scale will be negative.
When the upper part of the image is smaller than the lower part of the
image, press the control disc to the right. The number indication below
the bar scale will be positive.
Important Note
: It is not recommended to use this adjustment
function to compensate for geometric distortions or abnormalities in
the retro projectors picture. It is better to ensure that the proper
mechanical installation adjustments have be undertaken to obtain
correct geometry (refer to the installation manual.)
Select with
ê
or
é
then <ENTER>
GEOMETRY
SHIFT
SIZE
SIDE KEYSTONE
BLANKING
OPTIONS
