![background image](http://html1.mh-extra.com/html/barco/overview-d-series/overview-d-series_user-manual_4198086076.webp)
7. Maintenance and servicing
Barco - OverView D series - Doc-3353-2 - user's manual - Revision 04 - April 2005
_______________________________________________________________________
7-15
7.3.4.2
Inserting a lamp module
The following description applies if the lamp has already been removed as described above and the lamp cover
is still opened.
•
Fetch the lamp module on its housing. The power socket is on the right side.
•
Insert the lamp carefully. Take care that the "tubes" slide on the guide rods.
•
Press the lamp module tightly into its socket.
•
Lock the lamp into its position by pressing the locking slider to the left.
Figure 7-15
inserting the lamp and locking it
•
Close the lamp door
•
Use the hexagon key and lock the lamp door by turning the screw a quarter turn clockwise.
The lamp door must not be open f or more than 15 minutes. If not closed within this
period, the projector will show a warning, and then go to standby after another 5
minutes.
If the operation mode of the projector has been
Hot Standby
, the new lamp is immediately switched on.
In case the operation mode has been
Cold Standby
or
Auto switch
, the lamp will be switched on automatically
in case it becomes the active lamp (i.e. in case of a lamp failure of the other lamp or after the switch cycle.
After the replacement of a lamp module, the new serial number has to be entered, and it is
highly recommended to select the lamp optimization procedure, cf.
In emergency cases the lamp optimization procedure can be skipped for the moment and car-
ried out later.
Содержание OverView D Series
Страница 1: ...User s manual OverView D series...