Barco MCM-400 HFR, Руководство пользователя

Страница: 102 / 214

9. Advanced operation
9.1.4 The Geometry edit dialog
The images below show adjustments performed on a hatch pattern generated internally by the device (see
Internal patterns ).
The Geometry edit dialog
In the OSD, browse to Geometry > Edit , select one of the modes and press ENTER to display the semitransparent Geometry edit
dialog.
This Geometry edit dialog acts as an intuitive user interface to perform all the geometry adjustments on the fl y. Each individual
anchor point can be selected and moved to the desired location in real time.
Depending on the geometry mode, the dialog box may slightly differ, the dialog box below is for a 2x2 mode adjustment.
Image 9-7
The table below describes every item in the Geometry edit dialog box.
Field/Adjustment Description Notes
Level 2x2 Denotes the selected geometry adjustment
mode. Level can be 2x2, 3x3, 5x5, 9x9, 15x15
or 33x33.
Column Column number corresponding to the
selected anchor point. This number refers to the 33 x 33 grid.
Row Row number corresponding to the selected
anchor point. This number refers to the 33 x 33 grid.
PixelsX This slider bar and edit box are used to
de
fi ne the new position of the anchor point
along the X axis, relative to its original
position.
In table front mode, and if Axislink is set
to off, a positive value moves the anchor
point to the right side.
High values can introduce some clipping
effects.
PixelsY This slider bar and edit box are used to
de
fi ne the new position of the anchor point
along the Y axis, relative to its original
position.
In table front mode, and if Axislink is set
to off, a positive value moves the anchor
point down.
High values can introduce some clipping
effects.
Axis link See "Setting the Axis link to ON or OFF",
page 111. It is advised to leave Axislink to its default
setting, being off.
Select Mode / Adjust Mode / Edit Mode /
Change Mode See "Selecting an anchor point", page 102,
"Moving an anchor point in small steps",
page 104 and "Moving an anchor point in
large steps", page 105.
As soon as the Geometry dialog is displayed, the fi rst anchor point for this mode is by default selected.
Another anchor point in this adjustment mode can be selected at any time. The selected anchor point is marked with a small yellow
dotted box . The region of impact is marked with a blue dotted box .
98 R5909056 MCM-400 HFR 11/05/2016