![background image](http://html1.mh-extra.com/html/barco/fsn-series/fsn-series_user-manual_3894029032.webp)
32
FSN Series • User’s Guide
2. FSN-1400 Orientation
Hardware Description
The
Video Reference LED
indicates the status of the system’s analog video
reference input, via the
Vid Ref
connector on the
System Card
’s rear I/O card.
~
Green
= the system is configured for
External Reference
, a video
reference signal is present and the FSN-1400 is locked to the signal.
~
Red
= the system is configured for
External Reference
, the signal is
missing or the FSN-1400 is not locked to the signal.
~
Off
= the system is configured for
Free Run
.
3) Hinges
Two hinges are provided on the right side of the door, to facilitate door removal
and re-installation. See the “
Door Removal and Re-installation
” section below
for door removal and installation instructions.
^áê=cáäíÉê
An air filter is located on the inside of the front door, in the bottom half of the door. Using
the four thumb nuts, this filter can be easily removed and cleaned periodically, as required.
aççê=oÉãçî~ä=~åÇ=oÉJáåëí~ää~íáçå
Use the following steps to open and remove the FSN-1400 front door:
1.
On the
Latch
, press inwards on the top label that reads “
Push
.”
2.
Lift the lower portion of the
Latch
that reads “
Lift and Turn
.”
3.
Turn the
Latch
clockwise, and open the door.
4.
To remove the door, lift it up and off of its hinges.
Use the following steps to re-install the FSN-1400 front door:
1.
Align the female hinges on the door with the male hinges on the FSN-1400.
2.
Set the door down on the hinges until it is fully seated.
3.
Close the door.
4.
Turn the
Latch
counter-clockwise, then push the
Latch
in to re-seat it.
Note
If the
Power LED
is off, the
Video Reference LED
will also
be off.
Important
Operating the FSN-1400 without the door fully closed and the
filter installed will cause overheating and possible damage.