![background image](http://html1.mh-extra.com/html/barco/fl40-series/fl40-series_quick-start-manual_4129057003.webp)
AC
110-240V
Connect power
Press Power On Button
Installation Conditions
Installation Conditions
Ventilation Requirements
Ventilation Requirements
Power up procedure
Power down procedure
AC
110-240V
Pull out Connector
Press Power Button for 3 sec
250mm
250mm
1.
Plug in mains power cord
2.
The projector will run a start up procedure. When completed,
the standby button illuminates white. (Standby mode).
3.
Press power button again to bring the projector in ON mode.
When the power button backligh is steady blue,
the projector are ready for use.
1.
Press the power button for 3 seconds
2.
The power button will illuminate white, and
the projector enters the cooling down process.
3.
Wait until the cooling down process are
completed before removing the main power
cord from the projector
- Review source information in the status menu (LCD screen or OSD) and verify that the source signal is compatible.
- Use test image to verify that the correct aspect ratio is selected
- Reset color and display settings to factory settings
- Restart the projector. Let the unit cool down for at least 1 minute prior to restarting
- Check the lenght of the source cables, and try shorter cables
Failure indications
What to do when the content or color is not correct
Caution
Do not place heat sensitive
objects in the area of the
orange arrow
Ambient operating conditions:
Temperature: 10 - 40°C
Altitude 1500 - 3000m
Temperature: 10 - 35
°C
Humidity: 10 - 80% RH
Humidity: 10-80% RH
Altitude 0 - 1500m:
Power requirements:
100 - 240 V, 60 - 50 Hz
Dimensions excl. lens:
450 x 471 x 244mm (WxLxH)
Weight excl. lens: 21,5 kg
NOTE !
The operating conditions will change when dust or pollution filters are installed.
Refer to filter installation manual for correct data