![background image](http://html1.mh-extra.com/html/barco/barcodata-3300/barcodata-3300_installation-manual_473892007.webp)
2-3
Installation Mode
5975129 BARCODATA 3300 TCR
P
LUS
121098
Green focusing
a. Insure all convergence screws are adjusted to a length of about 33
mm (1.3") between the two plates.
b. Adjust the projection lens until optimal focus for point 1 is obtained.
c. Turn screw 2 for optimal focus of the corresponding green line 2
on the screen.
d. This alignment influences the other, so repeat if necessary steps
b. and c. until points 1 and 2 are focused.
e. Turn screw 3 for optimal focus of the corresponding green line 3 on
the screen.
f. Repeat if necessary the steps b. to e. until the complet screen is
focused.
g. Secure the projection lens by turning the fastener ring clockwise.
Green position
a. If necessary turn screw 5 until the two horizontal lines 5 on the
screen are on one horizontal line.
When the green pattern is correctly focused, press
EXIT
to return to
the
Test pattern
menu.
Blue on green convergence.
Push the control disc up or down to hightlight
Blue on green
and press
ENTER
to display the Blue on green test pattern.
The longest lines are the blue lines. These lines must be converged
with the green lines.
The drawn screws and numbers are displayed in blue.
Follow next steps :
Blue focusing
a. Insure all convergence screws are adjusted to a length of about 33
mm (1.3") between the two plates.
b. Turn screw 1 for optimal focus of the corresponding point 1 on the
screen.
c. Turn screw 2 for optimal focus of the corresponding point 2 on the
screen.
d. Due to interaction, it may be necessary to repeat step b. and c. until
point 1 and 2 are focused.
e. Turn screw 3 for optimal focus of the corresponding point 3 on the
screen.
f. Due to interaction, it may be necessary to repeat steps b. to d. until
point 1, 2 and 3 are correctly focused.
Select with or
then <ENTER>
<EXIT> to return.
CONVERGENCE
GREEN
BLUE ON GREEN
RED ON GREEN
HATCH
Blue position
g. Turn screw 4 until the red horizontal line coincide with the green
horizontal line in point 4 on the screen.
h. Turn screw 5 until both horizontal lines marked with 5 are on one
horizontal line.
i. Repeat step g. and h. until the horizontal lines are converged.
j. Adjust screw 6 for optimal convergence of the vertical lines.
k. Repeat step i. and j. until a optimal convergence in horizontal and
vertical direction is obtained.