2-2
8
Install Tank Holder Brackets and LP Regulator (For BGTSBLP Model)
CAUTION: Build your island before installing the LP Gas Tank and Partition Panel (not included in this unit).
Refer to the heights listed in Fig. 4 on page 9 for constructing your side burner island. An island unit is
not included with the purchase of your Side Burner.
Note: You will need to make 3 holes on your Island Bottom Panel before installing the Tank Tray Set.
You will also need to make a hole in your Island Bottom Panel to accommodate your LP Gas Tank. Make
sure the diameter of the hole is at least 9 inches. Make sure the depth of the hole is greater than the
height of the gas tank seat.
Install the Bracket with Regulator onto the Island Side Panel using 2 Pan Head Screws 3/16"x3/8".
Install the Stainless Steel Tube (not included in this unit) onto the manifold. Next, insert the other end
of the Stainless Steel Tube through the hole on the Island's Side Panel. Install the Stainless Steel Tube
onto the male fitting on the Bracket.
Install the Tank Tray Set onto the Island Bottom Panel using 3 Pan Head Screws 3/16"x3/8" as
shown in Fig. 3.
Place the LP Gas Tank into the Tank Tray Set so that the tank valve faces the right rear corner.
Install LP Regulator onto the Gas Tank.
Fig. 3
Island Bottom
Panel
Tank Tray Set
Pan Head Screw
3/16"x3/8"
Qty. 5
Part # S182G03061
