16
Please note when you initially light the unit you will need to push the control knob in and turn to
the left but continue pushing the control knob which will release the gas for it to ignite.
CORRECT POSITION OF THE FFD SENSOR
Please see the correct position of this sensor.
ADJUSTING SENSOR
(DISCONNECT FROM GAS SUPPLY DURING THIS PROCEDURE)
If the flame in the burner is going out after you light the unit you may have to slightly adjust the
position of the sensor.
This is easily done by loosening the two nuts on either side and moving the sensor up or down
and then retightening to fix in place.
FFD
FLAME FAILURE DEVICE (FFD)
The FFD is a safety feature of this unit that shuts off
gas to the appliance if the flame is not continuously
burning. Please note the sensor has been factory
fitted to the burner and is already in its correct
position.
FFD
Loosen the two nuts to the
thermocouple sensor, then
adjust the height to correct
position.
LOW SETTING
HIGH SETTING
Thermocouple
Sensor
Thermocouple
Sensor
ARROSTO GAS PIZZA OVEN-Manual_v5.indd 16
19/12/17 1:28 pm