14
LIGHTING THE PIZZA OVEN
WARNING: OPEN DOOR BEFORE LIGHTING.
Piezo Ignition
1. Make sure the valve, the hose and the regulator are connected correctly as per the assembly
instructions.
2. Open the gas control valve on the gas cylinder.
3. Push down the control knob and keep pressing while turning anti-clockwise to the
90º position (‘HIGH’ position). Keep the knob pressed and push the ignition button several
times until burner has lit. If the burner has not lit, repeat this process.
4. If the burner does not light after 3 attempts, turn off the gas tap, wait 5 minutes and
then repeat step 3. If the pizza oven still fails to light, please refer to the manual ignition
instructions below.
5. When the burner is lit, adjust the heat by turning the knob to the HIGH or LOW position.
6. After use, turn all control knobs to the OFF setting and turn off the gas control valve at the
cylinder.
Manual Ignition
1. Remove pizza stone from support grid.
2. Open the gas control valve at the cylinder.
3. Insert lit match through the supporting grid and place near the burner.
4. Push and turn the control knob anti-clockwise to the HIGH flame position.
5. If burner still fails to light after 5 seconds, turn to OFF position and wait 2 minutes. Then
begin again from step 3. If the burner still fails to light after several attempts, call the
customer service line -1300 301 392.
WARNING: IF THE BURNER FAILS TO IGNITE, TURN THE CONTROL KNOB OFF
(CLOCKWISE) AND ALSO TURN THE CYLINDER VALVE OFF, WAIT FOR
5 MINUTES BEFORE OPENING THE DOOR, AND REPEAT THE LIGHTING
PROCEDURE.
ARROSTO GAS PIZZA OVEN-Manual_v5.indd 14
19/12/17 1:28 pm
