barbas Panorama 110-55 PF2, Руководство по установке и обслуживанию

Страница: 35 / 84

5.2 Installation procedure
Note:
The appliance is factory set to the correct nominal heat input. The pilot light is
set to the correct level of gas consumption.
• Do all the procedures in this section. Optional procedures are indicated with
(optional).
5.2.1 Preparation
Do the following preparatory work before the start of the installation of the appliance:
• Make sure the gas supply line is near the intended location of the built-in operating
unit, to make it possible to connect the gas supply line with the gas regulator block in
the operating unit.
• Install a 230 VAC earthed electrical socket near the intended location of the appliance.
• If the optional Opti-Vent flue system will be installed, make sure to Install an extra 230
VAC earthed electrical socket near the intended location of the appliance
• Build the insulating walls behind the intended location of the appliance according the
requirements of chapter
4
before the installation of the appliance starts.
5.2.2 Install the appliance
Caution: Do not lift the appliance with any kind of forklift. This will cause
damage to the underside of the appliance. Only use the carrying handles to
move the appliance.
1. Install the carrying tubes on the appliance. Use the carrying handles to move the
appliance.
Note: The carrying handles are not included with the appliance.
2. Remove the carrying handles.
Figure 22. Appliance with carrying handles
Installation
Gas Fire Panorama 110-55 35