INSTALLATION (Day5)
Figure 7
6
Attach Lower Extension arm (F) to Pole
(A),
as shown in Figure 7.
Secure it with one Hex bolt M12x240 (#3),
two Flat washers M12 (#8), two Plastic
Washers M12 (#1), one Lock nut M12
(# ).
9
See
Figure 7.
Note
make sure Plastic washers go
:
between Lower Extension and Pole
.
3.
F
1
A
3
8
8
9
Figure 8
Attached Actuator (B) to Lower extension
Arm (F).
Slide Actuator plastic sleeve (C) over top of
Actuator (B), align the hole in the Plastic sleeve
with the hole in the Actuator, slide one Steel
Sleeve (#10) thru both parts, see Figure 8.
Hold the Actuator assembly, align Steel Sleeve
with the Rear hole of Lower extension Arm (F),
Attached them together with one Hex bolt
M12x240 (#3), two Flat washers M12 (#8), and
one Lock nut M12 (#9).
Attached Actuator (B) to Actuator mounting
plate (E).
See Figure 8
Move Actuator between two Mounting plate (E),
secure them together with one Hex bolt
M12x105 (#5), two Flat washer M12 (#8), two
Plastic washers M12 (#1), and one Lock nut
(#9).
Do not over tighten this bolt.
Note
make sure Plastic washers go between
:
Mounting plate (E) and Actuator (B). It prevents
painted parts from being scratched.
4.
5.
Attach Crank (L) to the bottom of Actuator with
supplied Lock pin.
A
E
E
5
8
1
1
L
8
9
C
B
10
3
8
8
9
F
Slide Plastic sleeve
over Actuator
STEP 4
STEP 5
