9
Replacing the Bean Hopper
To replace the bean hopper, line up the two tabs
on the base of the hopper (with the small tab on
the right side) with their respective slots in the
top of the grinder housing and insert the hop-
per into the grinder. Once the hopper is in place
rotate it clockwise to your desired grind setting.
Clearing a Clogged Grinder
If your grinder is not dispensing coffee normally, it could be clogged
with coffee powder. This can happen if the grounds bin or portafilter are
allowed to overfill and ground coffee gets backed up into the grounds
chute and grinding chamber. It can also happen with the build up of cof-
fee powder over time.
To clear the grinder remove any beans that remain
in the bean hopper, then remove the bean hop-
per. Also remove the ring burr and the grounds
bin. Check to see if the grounds chute is clogged
by looking at the exit of the grounds chute which
is located at the top of the recess that holds the
grounds bin (see photo # 1). If clogged, remove
the coffee grounds with a stiff piece of wire such
as a straightened jumbo paper clip and your
cleaning brush.
Photo # 1