29
33
Check electromagnetic braking air gap
34
Detection of emergency braking function
35
Detect reverse braking and regenerative braking function
36
Detection of belly switch function
37
Check the steering function
38
Check the function of lifting and lowering
39
Check the handle lever switch function
Comprehensive
40
Check whether all labeling clear full
41
Check the castor, if wear for height adjustment or replacement
42
Make a test run
LUBRICATING POINT
According to the maintenance list lubricating the marked point. Grease required specifications for: DIN
51825 standard grease.
CHECK AND REFILL THE HYDRAULIC OIL AGAIN
The hydraulic oil type required:
H-LP 46, DIN 51524
Viscosity is 41.4-47
According to the type of the oil are respectively 0, 7 L 16/20.
Waste materials such as waste oil, waste batteries or other materials must be according to the national
laws and regulations for processing and recycling, if need to pay to the recycling company for recycling.
Required to start the vehicle when the oil level should not be less than the minimum amount of oil.If it is
necessary to add oil to gas.
1. Steering bearing
2. Supporting roller bearing
3. Oil pump
4. Shaft
5. Binding point
6. Wheel load bearing
Figure. 16: lubrication points
Содержание EP16-N01
