Bante920 Benchtop pH/ORP Meter
5
3.
Insert the plastic rod into the irregular round hole and swivel the electrode arm 90
o
. Electrode holder is now ready to swing into desired position.
ADJUSTMENT OF ELECTRODE ARM:
After installation, if the electrode arm automatically rises or falls, you need to adjust the screws until arm locate at any position.
1.
Remove the plastic cover from the electrode arm.
2.
Use the screwdriver to tighten the screw moderately.
3.
Insert the plastic cover to previous position. Installation is completed.
Connecting the Electrode
1.
Take out the pH or ORP electrode from the packaging. Follow the steps below to place the electrode into left or right sides of the electrode arm.
2.
Insert the BNC connector into the corresponding connector socket. Rotate and push the connector clockwise until it locks. After connection is
completed, DO NOT pull on the sensor cord. Always make sure that the connector is clean and dry.
Screws
A. Insert the electrode
B. Hook up the cord
C. Hook up the cord
