1
I
Overview
Introduction
Thank you for selecting the DDS-12DW benchtop conductivity meter.
This user manual provides a step-by-step guide to help you operate
the meter, please carefully read the following instructions before use.
Any use outside of these instructions may invalidate your warranty
and cause permanent damage to the meter.
Environmental Conditions
Before unpacking, ensure that current environmental conditions meet
the following requirements.
•
Relative humidity is less than 80%
•
Ambient temperature between 0° C (32° F) and 50° C (122° F)
•
No potential electromagnetic interference
•
No corrosive gas exists
Packing List
The following list describes all components of the meter. If any items
are missing or damaged, contact the supplier immediately.
DDS-12DW meter
Electrode arm
9V DC power adapter
CON-1 conductivity electrode
TP-10K temperature probe
Conductivity standard solutions 84 µ S/cm, 1413 µ S/cm, 12.88 mS/cm
Meter Overview
1
Sensor connections
2
Base plate of electrode arm
3
Display
4
Membrane keypad
Connectors
1
Socket for conductivity electrode (6-pin mini DIN)
2
Socket for temperature probe (3.5 mm jack)
3
Socket for power adapter
Display
Icon
Description
Indicates that the meter is in the measurement mode
Indicates that the meter is in the calibration mode
Indicates that the meter is in the setup mode
Indicates that the measurement is locked
Indicates that the automatic temperature compensation
is enabled
Keypad
