Bano 5601-02, Инструкция по монтажу

Страница: 4 / 6

(4/6)
EN/
BANO TOILET GRAB BAR
CONTENTS:
C
Tiled wooden wall:
Make sure never to perforate wet walls completely. Drill holes with a 6 mm drill bit through the tiles only.
Clean and fill hole with sealant. Follow the instructions in figure
A
A
PLACEMENT ON WALL:
Please note that the product guarantee only applies when the wall and screws are dimensioned
according to «Byggebransjens Våtromsnorm» and Bano interface for products mounted in Norway.
For products mounted in other countries, please note that the product guarantee only applies when
wall and screws are dimensioned according to national guidelines/regulations and Bano interface.
B
B
1 wc grab bar
2 aluminum covers
1 plastic top cover w. double sided tape
Make sure never to perforate wet walls completely. Clean the holes after drilling. Make sure to use
acid resistant screws and sealant approved for application on wet walls. See figure
A
Tiled concrete wall:
Drill holes using a 12 mm drill bit through the tiles only. Switch to a 10 mm drill bit for further drilling through
the concrete. Fill the hole with sealant, place a nylon plug in the hole and fill the plug with sealant.
Se illustration
Other wall materials (bathroom boards, vinyl):
Make sure never to perforate wet walls completely. Drill holes which are dimentioned for said type of wall.
Fill the hole with sealant, place a nylon plug in the hole and fill the plug with sealant. See illustration
INSTALLATION:
Mount the brackets to the wall with two screws at the lower end and two screws at the upper end of each
wall bracket as shown in figure Make sure to use acid resistant screws.
COVER INSTALLATION:
Slide the bracket covers into the wall brackets from above with the bent ends
pointing upwards. Push the end cap in place at the top of the wall brackets
using the double sided tape.
For lagrer illustrations, please see page 2 and 3.
FIXING TO WOODEN WALL
FIXING TO CONCRETE WALL
A
Plaster wall
Wood Tiles
Concrete
4 acid resistant M8x60 mm screws and rivets (delivered separatly)
5601-02 Toilet grab bar 900 mm, grey
5601-B-02 Toilet grab bar 900 mm, black
5608-02 Toilet grab bar 700 mm, grey
5608-B-02 Toilet grab bar 700 mm, black
Recommended distance from the centre of the toilet to the centre of the toilet grab bar, as well as the distance
from the floor to screw hole no. 1 (left) and no. 6 (right) is shown in figure
Measure distances, level the brackets vertical and mark the screw holes No.1-4/5-8 as shown in figure
FIXING TO WALL:
A
B
3 4
1
2
7 8
5
6
C