P/N 112355 rev. A
9
WORLD-BEAM
®
QS30 Series –
Polarized Retroreflective Laser Sensors
Banner Engineering Corp.
•
Minneapolis, MN U.S.A.
www.bannerengineering.com • Tel: 763.544.3164
33.0 mm
(1.30")
12.5 mm
(0.49")
3.5 mm
(0.14")
44.0 mm
(1.73")
1.3 mm
(0.05")
22.0 mm
(0.87")
13.0 mm
(0.51")
5.0 mm
(0.20")
32.5 mm
(1.28")
35.0 mm
(1.38")
2 x ø3.3 mm (0.125")
max. torque
0.7 Nm (6 in lbs)
M30 x 1.5 Thread
max. torque
6 Nm (53 in lbs)
with included 30 mm
mounting nut
1
1
3
3
4
4
5
5
6
6
7
7
8
8
2
2
LO
DO
+
–
GAIN
Dimensions
QD Models
Cabled Models
Hookups
Cabled Models
QD Models
bn
Remote
Teach
bu
wh
bk
gy
+
10 - 30V dc
–
Load
Load
150 mA max. load
bn
Remote
Teach
Note: Pink wire not used
bu
wh
bk
gy
+
10 - 30V dc
–
Load
Load
150 mA max. load
Hardware Included:
(2) M3 x 0.5 x 28 stainless steel
machine screws, nuts and washers
Description of Laser Class
Class 1
Lasers that are safe under reasonably foreseeable
conditions of operation, including the use of
optical instruments for intrabeam viewing.
Reference 60825-1 Amend. 2 © IEC:2001(E),
section 8.2.
For Safe Laser Use
• Do not permit a person to stare at the laser from within the beam.
• Do not point the laser at a person’s eye at close range.
• Locate open laser beam paths either above or below eye level, where practical
CAUTION ...
Do not
Disassemble for Repair
Use of controls or adjustments or
performance of procedures other than
those specified herein may result in
hazardous radiation exposure; per
EN 60825.
Do NOT attempt to
disassemble this sensor for repair.
A
defective unit must be returned to the
manufacturer.
!
Accessory bracket dimensions
are shown on page 11.
