5.2 Specifications
Radio Range4
900 MHz, 150 mW: Up to 4.8 km (3 miles)
2.4 GHz, 65 mW: Up to 3.2 km (2 miles)
Radio Transmit Power
900 MHz, 150 mW: 21 dBm (150 mW) conducted
2.4 GHz, 65 mW: 18 dBm (65 mW) conducted, less than or equal to 20
dBm (100 mW) EIRP
900 MHz Compliance
FCC ID TGUDX80 - This device complies with FCC Part 15, Subpart C,
15.247
IC: 7044A-DX8009
2.4 GHz Compliance
FCC ID UE300DX80-2400 - This device complies with FCC Part 15,
Subpart C, 15.247
ETSI EN 300 328 V1.8.1 (2012-06)
IC: 7044A-DX8024
Spread Spectrum Technology
FHSS (Frequency Hopping Spread Spectrum)
Link Timeout
1 or 4 seconds
Power
10 to 30 V dc (Outside the USA: 12 to 24 V dc, ±10%). 5
Consumption: Less than 1.4 W (60 mA) at 24 V dc
Housing
Polycarbonate housing and rotary dial cover; polyester labels; EDPM
rubber cover gasket; nitrile rubber, non-sulphur cured button covers
Weight: 0.26 kg (0.57 lbs)
Mounting: #10 or M5 (SS M5 hardware included)
Max. Tightening Torque: 0.56 N·m (5 lbf·in)
Antenna Connection
Ext. Reverse Polarity SMA, 50 Ohms
Max Tightening Torque: 0.45 N·m (4 lbf·in)
Interface
Indicators: Red/Green Power LED, Red/Amber Signal LED
Wiring Access
Two 1/2-inch NPT
Discrete Inputs
Rating: 3 mA max current at 30 V dc
Sample Rate: 62.5 milliseconds
Report Rate: On change of state
Discrete Input ON Condition
PNP: Greater than 8 V
NPN: Less than 0.7 V
Discrete Input OFF Condition
PNP: Less than 5 V
NPN: Greater than 2 V or open
Analog Inputs
Rating: 24 mA
Impedance: Approx. 100 Ohms6
Sample Rate: 62.5 milliseconds
Report Rate: 1 second or On Change of State (1% change in value)
Accuracy: 0.1% of full scale +0.01% per °C
Resolution: 12-bit
Discrete Outputs
Update Rate: 125 milliseconds
ON Condition: Supply minus 2 V
OFF Condition: Less than 2 V
Discrete Output Rating (PNP)
100 mA max current at 30 V dc
ON-State Saturation: Less than 3 V at 100 mA
OFF-state Leakage: Less than 10
μ
A
Max. End-to-End Latency
300 milliseconds 7
Analog Outputs
Update Rate: 125 milliseconds
Accuracy: 0.1% of full scale +0.01% per °C
Resolution: 12-bit
Certifications
Environmental Conditions8
Rating: IEC IP67; NEMA 6
–40 °C to +85 °C (–40 °F to +185 °F)
95% maximum relative humidity (non-condensing)
Radiated Immunity: 10 V/m (EN 61000-4-3)
Shock and Vibration
IEC 68-2-6 and IEC 68-2-27
Shock: 30g, 11 millisecond half sine wave, 18 shocks
Vibration: 0.5 mm p-p, 10 to 60 Hz
4
Radio range is with the 2 dB antenna that ships with the product. High-gain antennas are available, but the range depends on the
environment and line of sight. To determine the range of your wireless network, perform a Site Survey.
5
For European applications, power this device from a Limited Power Source as defined in EN 60950-1.
6
To verify the analog input's impedance, use an Ohm meter to measure the resistance between the analog input terminal (AIx) and
the ground (GND) terminal.
7
From the sample point and with a good RF signal.
8
Operating the devices at the maximum operating conditions for extended periods can shorten the life of the device.
Sure Cross
®
DX70 Wireless Point-to-Point Kits
www.bannerengineering.com - Tel: 763.544.3164
21