DX80 Quick Start Guide
P/N 128185
Banner Engineering Corp.
•
Minneapolis, MN U.S.A.
www.bannerengineering.com • Tel: 763.544.3164
4
GETTING STARTED – NETWORK SETUP
The Banner DX80 wireless system is a network of devices
consisting of a Gateway and Node(s).
The network is defined by the Network ID (NID) assigned
to the Gateway and its Node(s). Additionally, each device
within this common network (NID) must have a unique
Device Address assigned.
Use the Rotary Switches (shown right) to define both the
NID and Device Address for each device. Follow the steps
below to set up your DX80 network.
Quick Start:
STEP 1
> Set Network ID & Device/Node Address
Remove rotary switch access covers.
Turn counterclockwise to remove and clockwise
to tighten
On the
Gateway
, set the Left Rotary Switch to 1.
The factory default NID setting on all devices is 1
On all
Nodes
(within the same network), set the Left
Rotary Switch to 1.
Assign the same NID to all devices within a
single network (0-15). A-F is 10-15 respectively.
On the
Gateway
, set the Right Rotary Switch to 0.
A Device Address of 0 on the Gateway will
display settings for the Gateway itself. To view
settings for another device on the network, adjust
the Right Rotary Switch on the Gateway to the
respective Device Address.
On the first
Node
(Device Address = 1), set the Right
Rotary Switch to 1.
On the second
Node
(Device Address = 2), set the
Right Rotary Switch to 2.
Continue setting the Device Address for each additional
Node using a unique number (..3,4,5).
Install rotary switch access covers.
SET
NETWORK
ID
SET
DEVICE
ADDRESS
User Action
Display/Status
Notes
Network ID (NID)
Device Address
Rotary Switches on
Gateway & Node
A successful RF link is identified by:
• The Gateway’s LED 1 is Green
• The Node(s) LED 1 is Flashing Green
Multiple Networks:
When more than one network is
operating in the same space, assign
a unique Network ID (NID) to each
network (shown right).
