Banner L-GAGE LE250 IO-Link, Инструкция по эксплуатации

Страница: 23 / 35

3.8 Display Menu (DISPLAY)
Use this menu to view or change the:
• Display units
• Display orientation
• Sleep mode settings
or
or
Go Back to Parent Menu
Select Menu Item
Press to Save Setting
Press and Hold to Go Back
to Run Mode
MENU DISPLAY
Sleep 1min
Sleep Disabled
Units in
Units mm
View Invert
View Normal
Sleep 5min
Sleep 15min
Sleep 60min
DISPLAY Sleep
DISPLAY Units
DISPLAY View
DISPLAY Zero
Zero Near
Zero Far
DISPLAY Shift
Shift Off
Shift SetZero
Shift AutoSet
Figure 21. Display Menu Map
3.8.1 Units
The Units option sets the displayed units to millimeters (mm) or inches (").
Navigate: MENU > DISPLAY > Units
Remote Input: Not available
Default: mm
3.8.2 Zero
Use this menu to select the zero reference location. The default is Near, where 0 = the front of the sensor.
• Near—0 = the front of the sensor; the measurement increases further from the sensor
• Far—0 = maximum range; the measurement increases closer to the sensor
Navigate: MENU > DISPLAY > Zero
Remote Input: Not available
Default: Near
3.8.3 Shift
Use this menu to select whether the sensor shifts the zero reference location based on the last TEACH process. The default
is off, where 0 = the front of the sensor or the maximum range.
• Off—0 = the front of the sensor or the maximum range, depending on the Zero setting.
• AutoSet—Shift the zero reference location to one of the taught positions with each TEACH. The zero reference
location is reset when teaching either output.
• SetZero—Teaches the current target as its new zero reference location.
3.8.4 View
The View option sets the display orientation of the sensor. For applications where the sensor must be mounted so that the
display is not right-reading, invert the display for readability. The Down and Up buttons do not change when the display is
inverted.
Navigate: MENU > DISPLAY > View
L-GAGE
®
LE250/550 IO-Link Laser Gauging Sensors
www.bannerengineering.com - Tel: 763.544.3164 23