2 ISM Radio Board (Slave ID 1)
Plug the ISM radio into the I/O base board with the U.FL antenna connector closest to the SMA connectors. Typically, users
will not need to adjust the DIP switch settings on the physical radio modules.
For the DXM1200 models, set the radio options using the LCD menu.
Figure 3. ISM radio board
DIP Switch
Bank 1
Button
LED
DIP Switch
Bank 2
1
1
ON
ON
Antenna
2
3
4
2
3
4
Button Operation
For DXM models without a LCD display, use the button to bind the ISM radio. For models with a LCD display, use
the ISM menu to bind the radio.
LED Operation
The LED located on the ISM radio module indicates power and communications traffic. ISM board LED operations
also display on the LED on the right side of the I/O base board.
•
Solid green DX80 ISM radio LED indicates power.
•
Flashing green MultiHop ISM radio LED indicates operation.
•
Red and green combined: Communications traffic and binding.
2.1 DIP Switch Settings for the MultiHop HE5 Board Module
D1 Switches
D2 Switches
Device Settings
1
2
3
4
1
2
3
4
Serial line baud rate 19200 OR User defined receiver
slots
OFF*
OFF*
Serial line baud rate 38400 OR 32 receiver slots
OFF
ON
Serial line baud rate 9600 OR 128 receiver slots
ON
OFF
Serial line baud rate Custom OR 4 receiver slots
ON
ON
Parity: None
OFF*
OFF*
Parity: Even
OFF
ON
Parity: Odd
ON
OFF
Disable serial (low power mode) and enable the receiver
slots select for switches 1-2
ON
ON
Sure Cross
®
DXM100-Sx Wireless Modbus Slave
www.bannerengineering.com - Tel: + 1 888 373 6767
7
