1. Marking the Door
1.1 Mark the top fixing point on the face of your door at the
desired height and horizontal distance from door edge.
1.2 In most instances, the vertical position should align
with the centre of the door stile. Pull 04 should only be
installed on a solid door. (Figure 1)
1.3 Using a spirit level, mark the bottom fixing point —
noting the CTC measurement is 335mm starting from 165mm
from the base of the pull handle.(Figure 2)
2. Fitting the Pull Handle (Concealed Fix Method)
2.1 Remove the pencil spindles from the pull handle by
loosening the grub screws. (Figure 3)
2. Fitting the Pull Handle (Concealed Fix Method) Cont.
2.2 Drill appropriate pilot holes for the wood screws at
each of the pencil spindle locations.(Figure 4)
2.3 Fit pencil spindles using wood screws provided.(Figure 4)
2.4 Place pull handle on pencil spindles and tighten grub
screws to secure.(Figure 5)
Figure 1
Figure 2
Fixing Points
CTC 335mm
Figure 3
(1)
(4)
(2)
Fixing
Points
CTC 335mm
Figure 4
(2)
(3)
2.
3.
4.
For number references please refer
to included items on reverse.
Figure 5
IMPORTANT:
Please install this hardware
in the following order to
ensure its warranty is not
voided.
1. Install the hardware on
raw/unfinished door using
the instructions provided.
2. Remove hardware (where
possible) and store safely.
Do not place tape onto
the hardware as this will
damage the finish.
3. Paint / finish door.
4. Reinstall hardware.
