banks six-gun, Руководство пользователя

Страница: 31 / 41

96808 v.14.0
31
9.
Tighten the turbocharger adapter
pipe fasteners to 20 lb-ft as shown in
Figure 33 .
10.
Reconnect the Exhaust Back
Pressure Sensor tap.
11.
connect the thermocouple wires
to the Six-Gun/EconoMind Diesel
Tuner with the supplied screws. The
YELLOW thermocouple wire attaches
to the free YELLOW wire on the Six-
Gun/EconoMind Diesel Tuner. The
RED thermocouple wire attaches to
the free RED wire on the Six-Gun/
EconoMind Diesel Tuner.
12.
Slide the heat shrink over the
exposed metal junction, and supply
moderate heat to seal the connection.
A heat gun works well.
13.
Route the thermocouple to
the exhaust manifold and install the
thermocouple in the fitting.
14.
Reconnect the ground cables to
the vehicles batteries.
Note: once the Six-Gun/
econoMind Diesel tuner is
powered up at key-on, it will
‘learn’ that a thermocouple
is installed and automatically
enable the eGt limiting function.
If the thermocouple is removed
after being installed and run on the
vehicle, the Six-Gun/EconoMind Diesel
Tuner will assume that the sensor or
connection has gone bad, and cease
adding power while triggering the
[2,3] diagnostic code (see Trouble
Shooting Section 10 ). To ensure that
the Six-Gun/EconoMind Diesel Tuner
operates properly after removing a
previously installed thermocouple,
see the ‘Clearing Learned Information’
Section 9 . eGt limiting will not be
operational and excessive eGts
may develop at higher power
levels.
-END, SEcTION 4-
Figure 31: Location to drill and tap the driver side exhaust manifold for the
thermocouple
Figure 32:
Exhaust manifold
tightening sequence
Figure 33: Turbocharger adapter
pipe torque specification