banks Power Stinger, Руководство пользователя

Страница: 25 / 42

96824 v.4.0
25
10.
Plug the EconoMind MAP
connector into the MAP sensor.
Plug the factory MAP connector
into the EconoMind MAP wiring
harness. Route the harness from the
EconoMind to the MAP sensor as
shown in Figure 31 . Use the supplied
zip ties to secure the MAP harness to
the factory harness. Failure to follow
the recommended harness routing
may result in a melted harness.
11.
Connect the sensor wire to the
EconoMind tuner with the supplied
screws. The YELLOW sensor wire
attaches to the free YELLOW wire on
the EconoMind tuner. The red sensor
wire attaches to the free red wire on
the EconoMind tuner.
12.
Slide the heat shrink over the
exposed metal junction, and apply
moderate heat to seal the connection.
A heat gun works well.
13.
Route the EconoMind ‘In-Cab
Cable’ through the firewall to the
passenger compartment. When
passing through the firewall, either
make a hole in a factory grommet or
drill a hole and use a new grommet.
If drilling, check the backside to make
sure there are no components that
may be damaged by drilling.
14.
Remove the lower driver side
interior panel that allows access to
the fuse box.
15.
From inside the vehicle, continue
to pull the cable through the firewall
until it is approximately 22” inside the
cab. Secure the cable to the lower
access panel area. Take precaution to
leave the three connectors accessible
for usage further in the installation
process.
16.
Locate the ‘OBDII Interface
Cable’ in your kit. Connect the ‘OBDII
Interface Cable’ to the vehicle OBDII
connector. Use the large cable tie in
your kit as shown in
Figure 33
to
secure the ‘OBDII Interface Cable’ to
the vehicle OBDII connector. Now,
connect the 8-pin connector from the
‘OBDII Interface Cable’ to the 8-pin
connector on the EconoMind ‘In-Cab
Cable.
Figure 27
Figure 28
Figure 29