banks Power Stinger, Руководство пользователя

Страница: 4 / 42

4
96824 v.4.0
Dear Customer, If you have
any questions concerning
the installation of your Banks
EconoMind Diesel Tuner,
please call our Technical
Service Hotline at (888) 839-
2700 between 7:00 am and
5:00 pm (PT). If you have any
questions relating to shipping
or billing, please contact our
Customer Service Department
at (888) 839-5600.
Thank you.
1.
For ease of installation of your
Banks system, familiarize yourself
with the procedure by reading the
entire manual before starting work.
This manual contains 42 pages of
copy, illustrations and parts listing.
If any pages are missing from this
manual please call Gale Banks
Engineering immediately for a
replacement.
2.
The exploded illustrations provide
only general guidance. Refer to each
step and section diagram in this
manual for proper instruction.
3.
Throughout this manual, the
left side of the vehicle refers to the
driver’s side, and the right-side to the
passenger’s side.
4.
Disconnect the ground cable from
the battery before beginning work. If
there are two batteries, disconnect
both.
5.
Route and tie wires and hoses
a minimum of 6 inches away from
exhaust heat, moving parts and sharp
edges. Clearance of 8 inches or more
is recommended where possible.
6.
During installation, keep the
work area clean. If foreign debris
is transferred to any Banks system
component, clean it thoroughly
before installing.
7.
When raising the vehicle, support
it on properly weight-rated safety
stands, ramps or a commercial hoist.
Follow the manufacturer’s safety
precautions. Take care to balance
the vehicle to prevent it from slipping
or falling. When using ramps, be
sure the front wheels are centered
squarely on the topsides; put the
transmission in park; set the parking
brake; and place blocks behind the
rear wheels.
Caution! Do not use floor jacks
to support the vehicle while
working under it. Do not raise
the vehicle onto concrete
blocks, masonry or any other
item not intended specifically
for this use.
Warning: Below 32 o F (0 o C)
or above 140 o F (60 o C), the
Banks iQ may be susceptible
to damage as a result of
extended direct exposure to
sunlight, heat or extreme cold.
It is highly recommended that
Banks iQ be removed from
its mounting location if the
vehicle will be subjected to high
concentrations of sunlight, heat
or cold for an extended period
of time. Gale Banks Engineering
is not responsible for damage
to Banks iQ resulting from
exposure conditions.
General Installation Practices