banks economind, Руководство пользователя

Страница: 11 / 33

10.
In the engine compartment find the
Fuel Rail Pressure (FRP) sensor on the
fuel rail. It is located on the drivers side of
the engine. Unplug the factory connector
and plug it into the corresponding male
FRP sensor connector on the Six-Gun/
EconoMind harness. Plug the Six-
Gun/EconoMind’s female FRP sensor
connector into the sensor. See Figure 6.
11.
Locate the Manifold Pressure (MAP)
sensor on top of the intake manifold.
Unplug the factory connector and plug it
into the corresponding male MAP sensor
connector on the Six-Gun/EconoMind
harness. Plug the Six-Gun/EconoMind’s
female MAP sensor connector into the
sensor. See
Figure 6
.
CAUTION: The Camshaft Position
(CMP) sensor and the Crankshaft
Position (CKP) sensor have the same
type of connectors and they are
in close proximity to one another.
Make sure the right connectors
are used when installing these
connections. Refer to Figure 7.
for their locations on the Six-Gun/
EconoMind Diesel Tuner wire
harness.
12.
Locate the Crankshaft Position
(CKP) sensor on the lower front left side
of the engine. It is behind the engine
crankshaft pulley (engine harmonic
balancer). Unplug the factory connector
and plug it into the corresponding male
CKP sensor connector on the Six-Gun/
EconoMind harness. Plug the Six-
Gun/EconoMind’s female CKP sensor
connector into the sensor.
Take care to route the wire
harness away from the power
steering pump pulley and secure
it with the supplied cable ties.
See Figure 8.
Figure 5