Before completing an exercise session always:
1. Allow time to slow your cool down, reducing your heart rate to a normal level before
completing your workout.
2. Grasp the handlebar and press the slow speed key. Slow your pace to an easy walk.
3. Ensure the running belt has come to a complete stop before exiting the treadmill.
WARNING:
Turn off and unplug the treadmill before proceeding with any maintenance or visual
inspections. Failure
to do so may result in serious injury. Note: Failure to perform the
required periodic and preventative maintenance can void your warranty.
AT THE END OF EVERY EXERCISE SESSION ALWAYS
1. Remove the Safety Key from the Console.
2. Use the Power Switch to turn the treadmill off.
3. Always position and store the Power Cord where it is clear from all pathways.
4. Unplug the Power Cord from the electrical outlet. This is especially important if you
are not going to use your treadmill for extended periods.
5. Wipe all treadmill surface with a dry cloth or towel especially perspiration on the
handlebars, console,running belt or other treadmill components.
STORAGE
●
Store your treadmill in a clean and dry environment. Ensure the Power Switch is off
and is unplugged from the electrical outlet.
MOVING
●
Check the Cylinder(10) into the locked position before moving the treadmill.
●
The treadmill has been designed and equipped with wheels (11) for easy mobility.
Before moving, ensure the Power Switch is in the 'OFF' position and the power cord is
unplugged from the electrical outlet.Tilt the base frame of the treadmill and then roll the
treadmill to the desired position.
LUBRICATION YOUR TREADMILL
The treadmills have already been spread with "Silicone Oil" in advance before leaving
the manufacturing plant. Silicone oil is without volatility and has gradually permeated
through the running belt. There will be no need to re-spread the oil in normal
circumstances.
To maintain the running belt, we have included a small bottle of "Silicone Oil ".
"Silicone Oil" may be re-spread once the resistance has been increased and the
running belt starts rubbing against the running deck. To hold open the center of the
running deck. Allow the silicone oil to 'set' for one minute before using the treadmill.
NOTE:
Only use "Silicone Oil" lubricants
for this equipment. In addition, do not
add any other oil ingredient; otherwise
the treadmill will be damaged. Do not
over-lubricate the walking board.
Excess lubricant should be wiped
off with a clean towel.
11
