Remote operation
You can operate Playmaker with
Beo4 and Beo6.
> Start playback from your hand-
held device.
> To select an AirPlay source, press
A.MEM
on Beo4. On Beo6,
press
AIRPLAY
*
2
.
> To select a source connected via
line-in, press
LIST
and bring up
A.AUX
in the Beo4 display, then
press the
centre
button. On
Beo6, press
LINE IN
.
*
2
> Use the volume button/volume
wheel to adjust volume.
2
*Your Beo4/Beo6 may be
configured differently. See the
documents supplied with your
Beo4/Beo6.
NOTE! Operation with the Beo4
remote control can take place
when
A.MEM
,
A.AUX
or any
audio source is shown in the
remote control display. On Beo6
AIRPLAY
and
LINE IN
must be
shown in the remote control
display.
Change the speaker output
level on Playmaker
You can change the maximum
speaker output level on your
Playmaker. The default setting is
78, which is suitable for most
Bang & Olufsen speakers and most
recordings.
> Bring up
A.SETUP
in the Beo4
display by pressing
LIST
repeatedly, then press the
centre
button.
> Press
LIST
repeatedly to bring up
S.STORE
in the Beo4 display and
then choose one of the
following settings by pressing a
number button:
No digits = maximum output
volume 78.
5 = maximum volume 55
7 = maximum volume 70
9 = maximum volume 90
(highest possible value)
> Press the
centre button
to store
the settings. The Mute/standby
button on Playmaker becomes
solid green for 1 second to
confirm that the settings have
been stored.
Cleaning
Wipe dust off the surfaces using a
dry, soft cloth. Do not use liquid
cleaners or aerosol cleaners.
To remove stains or dirt, use a soft,
damp cloth and a solution of water
and mild detergent, such as
washing-up liquid.
Important!
– Avoid placing the product in
direct sunlight or direct artificial
light, such as a spotlight.
– Make sure that the product is set
up, placed and connected in
accordance with the instructions.
– Place your product on a firm
surface.
– Do not subject the product to
high humidity, rain or sources of
heat.
– The product is intended for
indoor use in dry, domestic
environments only. Use within a
temperature range of 10–40°C
(50–105°F).
– If the product has been exposed
to temperatures below 5°C
(40°F), leave it at room
temperature and wait until the
product has regained normal
room temperature before it is
connected to the mains and
switched on.
– Leave enough space around the
product for adequate ventilation.
– Do not attempt to open other
parts of the product than the
back cover. Leave such
operations to qualified service
personnel.
13
Technical specifications, features
and the use thereof are subject to
change without notice.
