
Adjustment of the glass doors
- Open the glass doors, press
•
and wait for the glass doors to close and disconnect
main voltage.
- Remove the seven screws A in the back cover. Pull out the back cover by wrenching
the corners C of the back cover to the side.
- Remove the fi ve screws B, and lift PCB12/15 out of the cabinet.
- Loosen the top and bottom screws holding the maladjusted glass door on the wire
(only one door at the time).
- The maladjusted glass door can now be pushed to the middle-stop and the screws
at the top and at the bottom of the glass door have to be tighten fi rmly.
- Connect the main voltage. Open the glass doors, press
•
and wait for the glass
doors to close and disconnect main voltage.
- If necessary adjust the other glass door in the same way.
Note, be careful not to loosen both glass doors at the same time.
Repair tips, English 5.13
ABO-CENTER
v/HENRIKSENS
ELEKTRONIK