7
Connections
The Beolab Penta can be
connected to either a receiver, a
TV set, a Master Control Link 2 A
or a Master Control Link 2 AV
(MCL 2 A/2 AV).
For lengths and parts numbers
of the cables which can be used,
see the section “Optional acces-
sories”.
NOTE! Before connecting the
Beolab Penta to the receiver, TV
set or MCL 2 A/2 AV, make sure
that the MODE switch on the
front panel is set to OFF. This
precaution applies to both the
initial set-up and to later rearran-
gements of connections.
Do not switch on your audio or
video system until you have set the
switches on the front panel to their
correct position (see pp 11-13).
Connection to a Bang & Olufsen receiver or TV set or an MCL 2 A/2 AV
When connecting your Beolab
Penta, you may use
either
the
POWER LINK socket
or
the
SPEAKER LINK socket.
POWER LINK 1 & POWER LINK 2
sockets
(using an 8-pin DIN Power Link
cable).
The sockets marked POWER
LINK 1 & 2 are identical. This
means that either socket can be
used when you connect your
Beolab Penta by means of a
Power Link cable.
Plug one end of the cable into
one of the POWER LINK sockets
on the Beolab Penta.
Plug the other end of the cable
into one of the POWER LINK
sockets on your receiver, TV set
or MCL 2 AV.
Repeat the procedure for the
other speaker.
POWER LINK 1
POWER LINK 2
Содержание BeoLab Penta
Страница 1: ...B E O L A B P E N T A ...
Страница 19: ...3506182 0982 Printed in Denmark by Bogtrykkergården a s Struer ...